墙面快装板的安装很多人都不太会，今天小编就来为大家介绍下墙面快装板的安装方法，希望能帮助到大家。

Many people are not very good at the installation of wall mounted panels. Today, Xiaobian will introduce the installation methods of wall mounted panels to you, hoping to help you.

墙面快装板安装步骤一：

Installation step I of wall quick mounting plate:

拼缝处应装有密封胶，在完成前一道工序后，将被下一道工序覆盖。

The joint shall be equipped with sealant, which will be covered by the next process after the previous process.

墙面快装板安装步骤二：

Installation step II of wall quick mounting plate:

富美家快装板墙板的竖缝应采用槽形缝或工字形铝缝。“隐蔽工程”可分为水上安装，甚至可能危害人身安全。框架应与横梁连接，上部隔板，外墙板和门窗框应连接。

The vertical joint of Formica quick installation panel wall panel shall adopt slot joint or I-shaped aluminum joint. "Concealed works" can be divided into water installation and may even endanger personal safety. The frame shall be connected with the beam, and the upper clapboard, exterior wall panel and door and window frame shall be connected.

然后应安装楼板檩条，外面板应向下重叠。实际上，这种轻钢结构用于平整围墙和隔断墙的基础，更好地使用钢筋混凝土，安装楼梯，铺地板，然后向上安装一层，然后安装屋顶桁架和屋顶面板。

Then the floor purlins shall be installed, and the outer panels shall overlap downward. In fact, this light steel structure is used to level the foundation of the fence and partition wall, make better use of reinforced concrete, install stairs, lay the floor, then install a layer upward, and then install the roof truss and roof panel.

墙面快装板安装步骤三：

Installation step 3 of wall quick mounting plate:

安装门窗等，拉竖向支撑。还有就是卫生洁具啊、小五金之类的，嵌入式墙板的上下搭接缝应采用企口缝、电安装及防潮、防水等项目。

Install doors and windows and pull vertical supports. There are also sanitary ware, hardware and so on. The upper and lower lap joints of embedded wallboards should adopt tongue and groove joints, electrical installation, moisture-proof, waterproof and other items.

其中的每一个项目都不容忽视，如果哪一个环节出了问题，都可能带来严重的经济损失，表面装饰得再漂亮，也是徒劳；然后立柱子、墙梁或楼面次桁架的连接应使用螺栓连接。连接螺栓横向间距应不大于500mm（每块板宽度方向设置不少于两个螺栓）。

Each of these projects can not be ignored. If any link goes wrong, it may bring serious economic losses. No matter how beautiful the surface decoration is, it is futile; Then the connection of vertical column, wall beam or floor sub truss shall be connected by bolts. The horizontal spacing of connecting bolts shall not be greater than 500mm (at least two bolts shall be set in the width direction of each plate).

墙面快装板安装步骤四：

Installation step 4 of wall quick mounting plate:

嵌入式墙板安装应在冷弯薄壁型钢结构安装时及时镶人柱子两侧槽内。

The embedded wallboard shall be inserted into the slots on both sides of the column in time during the installation of cold-formed thin-wall steel structure.

以上便是问题的相关解答内容了，如果您想获取更多相关信息，就来关注我们网站https://www.fumeijia.net吧！

The above is the relevant answers to the questions. If you want to get more relevant information, please follow our website https://www.fumeijia.net Come on!