山东创图建筑装饰工程有限公司
18660816658
您当前位置: 防火板用来隔墙具体方法是什么？
来源：https://www.fumeijia.net/ 日期：2020-08-03 发布人：admin
今天针对防火板用来隔墙来说明下具体方法。
Today for the fire board used for partition to explain the specific method.
使用的具体步骤：
The specific steps are as follows:
1、防火板：一般建议采用厚度大于6mm的玻璃镁板作为隔断板。
1. Fireproof board: it is generally recommended to use glass magnesium plate with thickness greater than 6 mm as partition board.
2、配件：6毫米以上的床单固定在车架的龙骨上。采用3.5200毫米的沉头螺钉固定，钉头在板面上下方0.5毫米处，确保光洁度光滑。
2. Accessories: the bed sheet above 6 mm is fixed on the keel of the frame. Fix with 3.5200 mm countersunk screw, the nail head is 0.5mm above and below the board surface to ensure smooth finish.
3、安装：开始安装时，必须标记并标记龙骨的确切位置。垂直龙骨之间的距离为450-600mm。墙壁和门窗侧面的接缝应安装额外的龙骨。如果墙的高度大于2440mm，则必须在板的接头处安装支撑龙骨。
3. Installation: the exact position of the keel must be marked and marked at the beginning of installation. The distance between vertical keel centers is 450-600mm. Additional joists shall be provided for joints in the sides of walls and doors and windows. If the height of the wall is greater than 2440 mm, the supporting keel must be installed at the joint of the plate.
4、板间距：相邻板之间的间隙为4-6mm。板与地面之间的间隙必须为5mm。螺钉安装距为150mm，距板边10mm，距板角30mm。
4. Plate spacing: the gap between adjacent plates is 4-6mm. The gap between the plate and the ground must be 5mm. The screw installation center distance is 150 mm, 10 mm from plate edge and 30 mm from plate angle.
5、悬挂：悬挂厕所或厨房等重物时，必须用木板或龙骨加固，以免损坏。
5. Hanging: when hanging heavy objects such as toilets or kitchens, they must be reinforced with wood or keel to avoid damage.
6、接缝处理：在安装过程中，板和板留有4-6mm的间隙。用107胶水或超级胶水混合后，用刮刀涂抹刀片和间隙，然后用纸带或造型胶带粘贴并压平。
6. Joint treatment: in the process of installation, there is a gap of 4-6 mm between plates. After mixing with 107 glue or super glue, smear the blade and gap with scraper, then paste and flatten with paper tape or modeling tape.
7、油漆装饰：可采用喷涂、刷涂或滚涂，但刷涂时必须参照油漆的有关说明。
7. Paint decoration: spray, brush or roll coating can be used, but the relevant instructions of paint must be referred to when brushing.
8、装饰瓷砖：在浴室、卫生间、厨房、地下室等潮湿处安装时，面板上的瓷砖和龙骨之间的距离必须缩短到400毫米。每三片墙（约3.6毫米左右）必须有拉伸接缝。
8. Decorative tiles: in the bathroom, bathroom, kitchen, basement and other humid places, the distance between the tiles and keel on the panel must be shortened to 400mm. Every three walls (about 3.6 mm) must have tensile joints.
9、隔音墙：如果墙体具有很高的隔音效果，墙壁和板材必须紧密封闭，矿物棉应填入空墙。如果龙骨两侧由两个不同厚度的板制成，则隔室的效果更好。
9. Sound insulation wall: if the wall has high sound insulation effect, the wall and board must be closed tightly, and mineral wool should be filled into the empty wall. If the two sides of the keel are made of two plates of different thickness, the effect of the compartment is better.
10、防冲击墙：建议选用8毫米以上的防火板或单层防火板。第二块板用较长的螺丝加固。该方法可提高材料的抗冲击、隔热、隔声、耐火性能。
10. Anti impact wall: it is recommended to use the fireproof board of 8mm or single layer. The second plate is reinforced with longer screws. This method can improve the impact resistance, heat insulation, sound insulation and fire resistance of the materials.
以上是关于防火板用来隔墙具体方法的相关内容，希望对大家有所帮助，想要了解更多内容请继续关注我们的网站。
The above is about the fire board used for partition concrete method related content, hope to help you, want to know more content, please continue to pay attention to our website.
上一篇：富美家为您介绍防火板到底防不防火？
下一篇：防火板日常保养的小细则！
Related products相关新闻
产品销售热线：18660816658
技术方案咨询：18560211715
仓库地址：山东省济南市天桥区金鑫产业园303仓库