山东创图建筑装饰工程有限公司
18660816658
您当前位置: 关于防火板的起泡问题？
来源：https://www.fumeijia.net/ 日期：2021-06-23 发布人：admin
防火板起泡原因可根据挑破起泡处后出现的材质判断：
The cause of blistering can be judged according to the material after the blistering place is broken
1.起泡处挑破后现牛皮纸底板，可判断为防火板质量差，需购买高质量防火板
1. After the blister is broken, the kraft paper bottom board is found. It can be judged that the quality of the fireproof board is poor, so it is necessary to buy high-quality fireproof board
2.起泡处挑破后现基材，原因为施工不成熟，以下为导致防火板起泡的施工原因、避免方法、和解决方法。
2. The base material is found after the blistering place is broken. The reason is that the construction is not mature. The following are the construction reasons, avoidance methods and solutions of blistering of fireproof board.
防火板起泡的施工原因：
The reasons for the blistering of fireproof board are as follows
1.施工时施压不够，不均匀
1. Insufficient and uneven pressure during construction
2.胶水局部未干就贴合：
2. The glue is not dry on the part
a、晾置时间不够，胶水未干；
a. The drying time is not enough and the glue is not dry;
b、施工环境湿气过大，胶水没干透，出现假干现象，导致粘接不牢；
b. Too much moisture in the construction environment, the glue did not dry thoroughly, resulting in false dry phenomenon, resulting in poor bonding;
c、板材潮湿，粘不牢；
c. The board is wet and not firm;
d、胶水涂刷局部过多，干不了；
d. Too much glue can't dry;
3.胶水局部缺胶。
3. The glue is partially lacking.
防火板起泡的避免方法：
Methods to avoid blistering of fireproof board:
1.均匀用力施压至贴合。
1. Press evenly to fit.
2.a、适当延长晾置时间：
2. A. extend the airing time appropriately
b、通风干燥、用太阳灯照射或更换场所；
b. Ventilate and dry, irradiate with sun lamp or change place;
c、粘物晾干或烘干后再使用；
c. The stickies can be used after drying or drying;
d、均匀、一次性刮胶.
d. Uniform, disposable scraping
3.均匀刮胶，不要缺胶.
3. Scrape the glue evenly without missing glue
防火板起泡的解决方法：
Solution to blistering of fire-proof board:
在干燥的环境下，于防火板上放置毛巾，用电熨斗烫平。
In a dry environment, place a towel on the fireproof board and iron it with an electric iron.
上一篇：富美家®金麗®金属耐火板的自然魔法
下一篇：选择竹木式快装板的原因？
Related products相关新闻
产品销售热线：18660816658
技术方案咨询：18560211715
仓库地址：山东省济南市天桥区金鑫产业园303仓库